What Are The Precautions During The Use Of Pet Feed Production Lines?

With the increasing variety of pets, there is a distinction between adults and children, and the demand for pet food is also constantly increasing. This production equipment can adjust the process parameters such as raw materials, temperature, and moisture to make the product have the characteristics of novel shape, good taste, rich nutrition, and delicate tissue, suitable for the taste of different pets. This pet food production line is widely suitable for the production of dogs, cats, fish and shrimp, foxes, birds, and various pet feed, making it an ideal choice for different manufacturers.

What are the precautions during the use of pet feed production lines? Below, the editor will introduce to you:

l. Long term homework should be fixed on a cement foundation. If the workplace is frequently changed, the pet feed equipment and electric motor should be installed on the base made of angle iron. If the pet feed equipment is powered by diesel, the power of the two should be matched, that is, the diesel engine power should be slightly greater than the power of the pet feed equipment, and the pulley grooves of the two should be consistent, and the outer end face of the pulley should be on the same plane.

2. After installation, check the tightness of each fastener and tighten it if there is any looseness.

3. The pet food production line needs to check whether the belt tightness is appropriate, and whether the motor shaft and pet feed equipment shaft are parallel.

4. Before starting, rotate the rotor by hand to check whether the teeth, hammer pieces, and rotor operate flexibly and reliably, whether there is any collision inside the shell, whether the rotation direction of the rotor is consistent with the direction indicated by the arrow on the machine, and whether the lubrication between the motor and the powder machine is good.

5. Do not replace the belt pulley casually to prevent the crushing chamber from exploding due to high rotation speed or affecting work efficiency due to low rotation speed.

6. After starting the crushing table, run it for 2-3 minutes without any abnormalities before feeding.

7. Pay attention to the operation of pet feed equipment at all times during work, ensure even feeding to prevent blockage and overloading of the vehicle, and avoid prolonged operation. If vibration, noise, high temperature of bearings and body, or external spraying are found, the machine should be stopped immediately for inspection, and the fault should be eliminated before continuing to work.

8. The crushed materials should be carefully inspected to avoid accidents caused by hard objects such as copper, iron, and stones entering the crushing room.

9. Operators should not wear gloves and should stand on the side of pet feed equipment when feeding to prevent rebound debris from damaging the face.

10. When the pet food production line is blocked, it is strictly prohibited to forcefully feed or pull out feed with hands or wooden sticks.